basic settings

Alternativinhalt

Leg length adjustment

When activating the slider release mechanism, sliders can be adjusted to the length of the patient's legs.

Basic setting:
Press the "banana-shaped button" and move the sliders into the desired postion. Release the "banana-shaped button"

>>show CAMOped Trailer

Alternativinhalt

Angle limiter

Before you start, check that the angle limiters are adjusted according to your physician's recommendations. Both sliders must have the same angle limiter adjustment. Through various settings of the angle limiter it is possible to determine the minimum and maximum positions for bending and stretching. To set, press the stops outwards and set the desired values. Let the stops click into position

Basic setting:
Upper stop 9 (approx. 90°)
Caution: The numbers printed on are approximate values only. Exact angle details must be measured at the knee of the patient.

>>show CAMOped Trailer

Alternativinhalt

Foot stretch resistance

Enables the resistance for foot stretching to be changed.
The resistance can be changed by varying the tension of the orange rubber band.
Hook in rubber band at bottom – low resistance in ankle joint
Hook in rubber band at top - high resistance in ankle joint

Basic setting:
Rubber band attached to lowest notch (low resistance)

>>show CAMOped Trailer

Alternativinhalt

Resistance adjustment

By turning the positioning wheel the desired movement resistance can be set.
The set value (0-3) can be read from the position marked.

Basic setting:
0 (no resistance)

>>show CAMOped Trailer

Germany	Switzerland
USA	Spain
Australia	China
England

basic settings

Service

OPED products

OPED

Country sites